Development setup for STM32MPU Embedded Software

来自百问网嵌入式Linux wiki
Wiki讨论 | 贡献2020年11月3日 (二) 11:28的版本 (创建页面,内容为“<noinclude> {{NoIndex}} Category:Sub-articles {{PublicationRequestId | 7565 | 2018-06-18 | PhilipS}} This article presents the recommended material for developm…”)
(差异) ←上一版本 | 最后版本 (差异) | 下一版本→ (差异)

<securetransclude src="ProtectedTemplate:PublicationRequestId" params="7565 | 2018-06-18 | PhilipS"></securetransclude>

This article presents the recommended material for development on a host PC.

Warning.png To use this setup efficiently, we recommended reading the Developer Package or Distribution Package articles relative to your STM32 microprocessors Series: Category:Developer Package or Category:Distribution Package


The recommended setup for the development PC (host) is specified in the following article: PC prerequisites.

Whatever the development platform (board) and development PC (host) used, the range of possible development setups is illustrated by the picture below.

文件:Development setup.png
Development setup for Developer and Distribution Packages


The following components are mandatory:

  • Host PC for cross-compilation and cross-debugging, installed as specified above
  • Board assembled and configured as specified in the associated Starter Package article
  • Mass storage device (for example, microSD card) to load and update the software images (binaries)

The following components are optional, but recommended:

  • A serial link between the host PC (through Terminal program) and the board for traces (even early boot traces), and access to the board from the remote PC (command lines)
  • An Ethernet link between the host PC and the board for cross-development and cross-debugging through a local network. This is an alternative or a complement to the serial (or USB) link
  • A display connected to the board, depending on the technologies available on the board: DSI LCD display, HDMI monitor (or TV) and so on
  • A mouse and a keyboard connected through USB ports

Additional optional components can be added by means of the connectivity capabilities of the board: cameras, displays, JTAG, sensors, actuators, and much more.