SPDIFRX device tree configuration
目录
Article purpose
本文介绍了在将SPDIFRX internal peripheral分配给Linux® OS时如何配置。 在这种情况下，它由ALSA framework控制。
使用 device tree 机制执行配置，该机制提供了SPDFIRX linux driver使用的SPDIFRX外设的硬件描述。
如果外围设备已分配给另一个执行上下文，请参阅 How to assign an internal peripheral to a runtime context文章，以获取有关外围设备分配和配置的准则。
DT bindings documentation
STM32 SPDIFRX设备树绑定[1] 文档描述了所有必需的和可选的配置属性。
DT configuration
This hardware description is a combination of STM32 microprocessor [2] and board device tree files. See the Device tree for an explanation of the device tree file split.
STM32CubeMX can be used to generate the board device tree. Refer to How to configure the DT using STM32CubeMX for more details.
DT configuration (STM32 level)
The SPDIFRX node is declared in stm32mp157c.dtsi[2]. It describes the hardware parameters such as register addresses, interrupt, clock and DMA. This set of properties may not vary for a given STM32MPU.
 |
This device tree part is related to STM32 microprocessors. It must be kept as is, without being modified by the end-user. |
DT configuration (board level)
The SPDIFRX is an audio peripheral, which can be used as a component of a soundcard through Linux® kernel ALSA framework. This part of the device tree allows the configuration of the SPDIFRX to implement a soundcard. Refer to soundcard configuration for examples of SPDIFRX configuration on various boards.
DT configuration examples
&spdifrx {
pinctrl-names = "default", "sleep";
pinctrl-0 = <&spdifrx_pins_a>;
pinctrl-1 = <&spdifrx_sleep_pins_a>
/* Use spdifrx_pins_a instead of spdifrx_sleep_pins_a configuration,
to allow IEC958 status bits capture, when an audio stream record is
not active. Note that sleep state has to be defined, to allow pin state
recovery from low power modes. */
spdifrx_port: port {
spdifrx_endpoint: endpoint {
remote-endpoint = <&spdif_in_endpoint>;
};
};
};
How to configure the DT using STM32CubeMX
The STM32CubeMX tool can be used to configure the STM32MPU device and get the corresponding platform configuration device tree files.
The STM32CubeMX may not support all the properties described in the above DT bindings documentation paragraph. If so, the tool inserts user sections in the generated device tree. These sections can then be edited to add some properties and they are preserved from one generation to another. Refer to STM32CubeMX user manual for further information.
